Sigma 2-5, Operating Instruction

Page: 28 / 55

Operating Manual SIGMA 2-5, page 28 of 55
03/06
3.4 Initial Start-Up
Attention!
Before initial start-up please take care that your centrifuge is orderly installed
(refer to chapter 3.2 "Installation").
3.4.1 Switching on of the Centrifuge
Press mains switch (right side panel).
−
The centrifuge display is illuminated.
3.4.2 Opening Lid
Press the Lid-key.
−
The lid opens.
3.4.3 Installation of an Angle Rotor and a Swing-out Rotor
Put a rotor onto the shaft and fasten it by screwing the rotor tie-down screw
clockwise onto the drive shaft. Please use the supplied rotor wrench and hold the
rotor with one hand (refer to chapter 3.3 "Insertion of rotor and accessories").