FORM SIG 085
Revised 6-01-18
Page 2 of 4
!
!
SETTING HOT LIMIT STOP
IT IS THE RESPONSIBILITY OF THE INSTALLER TO SET THE MAXIMUM OUTPUT TEMPERATURE OF THE VALVE AS SPECIFIED BY
THE AUTHORITY HAVING JURISDICTION IN ACCORDANCE WITH ASSE/ANSI 1016-2005 4.2.2 REQUIREMENTS.
thermometer or calibrated sensing device to accurately measure the outlet water temperature.
2. Turn off the water using both screw driver service stops.
3. Expose the top of the cartridge by removing the top hex cap from the valve body. FIG. 2
4. Remove the temperature ring by placing the blade of a knife into the groove and
prying it off. FIG. 3. It is not necessary to remove the inner hex nut.
5. Locate the stop tab on the bottom of the ring. The further it is re-oriented in a counter-clock
vary and water supply temperatures vary as well.
6.
IMPORTANT!! BEFORE RE-ORIENTING THE RING, BE SURE THE STEM IS IN THE FULL OFF
POSITION.
maximum hot water temperature.
FIG. 2
FIG. 3
HEX CAP
TEMPERATURE
RING
1. Install extended stem and all thread onto cartridge stem. Fully seat stem onto cartridge by tightly securing all
thread nipple and locking nut onto valve. Install plate and centering nut. FIG 4a.
to extend. FIG 4b.
3. Place handle on stem and measure excess between escutcheon and handle base. Remove handle and cut
excess from end of stem using cut marks provided. FIG 4c.
4.
FOR TUB/SHOWER TRIM:
REPLACEMENT PARTS:
18.30.893 Cartridge
18.30.894 Diverter Cartridge
18.30.891 16 pt. stem extension
18.30.892 20 pt. stem extension
18.30.890 All thread
FIG. 4c
Cut this distance
from end of Stem Extension
so handle sits just above
the escutcheon
Gap
Handle
Stem Extension
Diverter Handle Sleeve
Diverter Handle Stem and Sleeve
thread directly onto Valve Extension
FIG. 4a
Trim Plate
Trim Plate Centering Nut
(not used on all handle trim)
FIG. 4b
Cut All-thread Flush with
top of escutcheon
Escutcheon
All-thread
Cut
INSTALLING TRIM
