SP3150A/SP3050A
4
EC Declaration of Conformity
Compliance was demonstrated to the speci
fi
ca
�
on as listed in the O
ffi
cial Journal of
the European Communi
�
es: Low Voltage Direc
�
ve 2014/35/EU.
IEC/EN 61010-031:2015 Safety requirements for electrical equipment for measurement,
control and laboratory use – Part 031: Safety requirements for handheld probe
assemblies for electrical measurement and test.
General Safety Information
Observe generally accepted safety procedures in addi
�
on to those listed
here to avoid personal injury or damage to equipment.
The overall
safety of any system incorpora
�
ng this accessory is the
responsibility of the assembler of the system.
Connect only to grounded instruments.
Use only with compa
�
ble Siglent
oscilloscopes that have their BNC input connected to an earth ground. Do not
connect the probe reference lead to any point which is at a poten
�
al other than
earth ground.
Connect and disconnect properly
. Connect probe to the oscilloscope before
connec
�
ng it to the test circuit. Disconnect the probe input and reference lead
from the test circuit before disconnec
�
ng from the oscilloscope. Do not connect
or disconnect probes while they are connected to a voltage source.
Do not overload.
Do not apply any poten
�
al to the probe leads that exceeds
the maximum ra
�
ng of the probe.
Always comply with the Voltage vs.
Frequency Dera
�
ng Curve.
Observe all terminal ra
�
ngs.
Observe all markings on the oscilloscope before
connec
�
ng. Consult the oscilloscope product manual for further ra
�
ngs
informa
�
on.
Do not remove probe casing.
Touching exposed connec
�
ons may result in
electric shock.
Use indoors only within opera
�
onal environment listed.
Do not use in wet or
explosive atmospheres. Keep product surfaces clean and dry.