6
until the display comes into focus and the target is seen as sharp as possible. If the diopter is not adjusted
to your particular eyesight, you may not be able to clearly focus your target.
3. Measuring: To measure the distance to a target, follow these steps:
ACTION
RESULT
↓
Re-press POWER Button
Device turns off after 10 sec.
Measured Distance
↓
↓
Press POWER Button
Aim reticle at target
Display Illuminates
↓
↓
4. Selection of Unit of Measure: To change the Unit of Measure, hold down the MODE button for 3 seconds.
The display will change from METERS to YARDS or from YARDS to METERS.
5. Distance Range Setting: To change the Distance Range Setting on the display to reflect the approximate
range of your target, press the MODE button once after the device has been turned on to rotate from >150
meters/yards to <150 meters/yards. The display will show >150 when set to measure distances greater than
150 meters/yards and will show nothing when set to measure distances of less than 150 meters/yards.
CAUTION:
The use of adjustments and controls, or performance procedures, in a way not specified in this
manual, may result in hazardous radiation exposure.
