.
,/tr>
23.
Glue the two F-19 pieces to the front top of F-6. When the glue is dry, sand the F-19's flush with the F-1's on the fuselage
sides.
24.
Glue F-20A and F-20B to the rear of F-20. Bend the landing gear wire using the pattern on the plan. Glue the landing gear
wire into the slot between F-20A and F-20B. Make sure to attach the wire so that the landing gear angles forward as
shown on the plan.
25.
Glue the landing gear assembly to the front of F-6.
26.
Glue the 1/16" sq. balsa stringers to the bottom of the fuselage between F-10 and F-12.
27.
Glue the 1/16" sq. stringer to the fuselage side between F-10 and F-5. The outside face of the stringer should be flush with
the outside of the fuselage side.
28.
Make the windshield braces from 1/16" sq. balsa strip and glue into position as shown on the plan.
29.
Glue C-3A to the front of F-10.
30.
Pin C-3 to your building board and glue parts C-1 and C-2 into position carefully at the ends only.
31.
Glue C-4 to the front of C-1 and C-2. The flat edge of the hole in the center should be aligned with the flat edge on the hole
in the center of F-10.
32.
Carefully cut the centers of C-1 and C-2 away.
33.
Add the 1/16" sq. balsa stringers to the cowl.
34.
Carefully glue C-5 and the two C-6's to the front of the cowl.
35.
Sand the front lip of the cowl to the shape shown on the plan. Sand the cowl smooth all over and glue it to the front of the
fuselage.
36.
Assemble the removable nose block from two NB-1's and two NB-2's.
37.
Adjust the center hole to establish the proper down thrust and right thrust and then assemble the propeller assembly and
test fit to the front of the model.
38.
Sand the fuselage smooth all over.
39.
Cut the tail post away at the rear end of the stabilizer slot.
40.
Cut and test fit the windshield.
41.
Test fit the tail surfaces to fuselage.
42.
Set these parts aside until needed later.
Building the Wings
43.
Pin the 3/32" x 1/4" balsa spar to the plan. Pin W-5 in place over the plan. Pin the 3/32" x 1/4" balsa trailing edge into
position over the plan. Pin W-9 and W-10 into position.
44.
Pin W-1 into position. Use the dihedral gauge to angle the rib toward the wing tip and then glue W-1 into position.
45.
Glue the six W-2 ribs into position 90 degrees to the building board.
46.
Glue the two W-3 ribs into position.
47.
Glue the 1/8" sq. leading edge into position.