.
27. Raise the wing tip 1 3/8" at W-8 and glue the left wing to the center section.
28.
Glue the right wing panel to the center section as you did the left.
29.
Glue the 1/16" sq. leading edge spars into position, cracking them at ribs W-2 and W-3. These strips should extend past W-
8 at the wing tip.
30.
Test fit the tip to the wings. Bevel the bottom edge of the tip and bevel the spars to fit flush with the top of the tip. Now glue
the tips into position.
31.
Remove the wing from the plan and sand all of the edges round.
Cover the Model
32.
Sand the entire model smooth with 400 grit sandpaper.
33.
Coat the outside edges with two coats of clear dope.
34.
Attach the tissue to the model with clear dope mixed 50/50 with thinner.
35.
Lightly mist the model with water to shrink the tissue.
36.
Apply two coats of thinned dope to the entire model.
37.
Carefully apply the water slide decals to the model.
38.
Draw additional details on the model with a waterproof marker.
Final Assembly
39.
Glue the canopy to the fuselage.
40.
Trim the belly scoop support from the side frames.
41.
Glue the wings into position on the model.
42.
Test fit and glue the stabilizer to the rear fuselage being careful to maintain proper alignment.
43.
Glue the rudder to the fuselage accurately.
44.
Assemble the propeller assembly using the hardware provided.
45.
Glue the propeller assembly into the removable nose block. Be sure to use the correct amount of down and right thrust.
46.
Assemble the exhaust stacks from the parts provided, paint them black and glue to the fuselage as shown on the plan.
47.
Trim the plastic spinner, paint and glue to the propeller.
48.
Assemble the landing gear as shown on the plan. The landing gear should not be glued to the model so that it can be
removed for flight. You may glue it onto the model if desired.
49.
Tie and install the rubber motor using the 3/16" dowel at the rear end to retain the rubber motor.
50.
Balance the model at the point shown on the plan. Add weight to the nose or tail as required to achieve the proper balance.
51.
Your model is now complete. You MUST READ AND FOLLOW all of the safety rules. We hope that you have enjoyed
assembling your model and hope that you enjoy many fine flights.