Sierra Wireless mangOH, User Manual, Page: 24 / 32

AirPrime MC Series Dev Kit Quick Start Guide
24 Proprietary and Confidential - Contents subject to change 2130705
Figure 3-22: mangOH—Reset Switches
Configure Board
The mangOH Development Board includes several switches and jumpers used to
configure the board and module‘s operation, as detailed in
Table 3-2 on page 24
through Table 3-9 on page 26.
To locate these switches and jumpers, see Figure 3-23 on page 27 and
Figure 3-24 on page 28.
Table 3-2: CN1204—Board Power (+5 V) Select
a
a. Required: Select one option only (Jump 1–2 or Jump 2–3)
Function
Jump
1–2
Jump
2–3
Power supplied by USB cable (through CN311–USB port) Yes
Power supplied from Wall cube brick (through CN1200–barrel jack
power) Yes
Table 3-3: CN1203—Battery Recharge Select
Function Jump 1–2
Battery will recharge while power is supplied by USB or DC Yes
a
a. Jumper must not be used if there is no battery connected.
Battery will not recharge No
Arduino reset
Board reset
(SW400)
(SW1500)