Rev 2 Jun.15
Proprietary and Confidential - Contents subject to change
17
Insert SIM Card(s)
The mangOH Development Board supports dual SIM functionality (if supported
by the CF3 module) through a standard mini-SIM slot (hot-swappable) and a
micro-SIM slot (not hot-swappable).
To use a UMTS/LTE module to establish a mobile network connection, you must
install one (or two) SIM cards:
•
Live card(s) with active accounts,
or
•
Test card(s) for use with a call box (for example, an Agilent 8960 or
Rohde & Schwarz CMU200)
Note: A SIM card is not required if you want to connect to a LAN using the Ethernet port.
To install the SIM card(s):
1.
Place the Dev Kit face-down (as shown).
Figure 3-11: mini-SIM Slot (CN801) and micro-SIM Slot Locations
2.
Insert the SIM card(s) into the desired slot(s) with circuitry face-down—note
the locations of the notched corners of the cards in the following image.
Note: The micro-SIM connector is a dual-connector—the micro-SIM goes in the lower
slot (as shown below), and a micro-SD can be placed in the upper slot.
Figure 3-12: SIMs Inserted
mini-SIM
(CN801)
micro-SIM
(CN801)
