Rev. 6 Oct.18
Proprietary and Confidential - Contents subject to change
13
1
1: About This Guide
Introduction
This document describes supported standard and proprietary AT
commands available for Sierra Wireless AirPrime
®
WP products, and
provides details where commands vary from the standards.
Important:
This document applies to the following WP Series module
groups (as of date of publication): WP85xx, WP75xx, WP76xx, WP77xx.
These commands are intended for use by OEMs, and are
supplemental to the standard AT commands for GSM devices defined
by the 3GPP (3rd Generation Partnership Project) in
TS 27.007 AT
command set for User Equipment (UE)
and
TS 27.005 Use of Data
Terminal Equipment—Data Circuit terminating Equipment (DTE-
DCE) interface for Short Message Service (SMS) and Cell Broadcast
Service (BSE)
.
Note: For questions or concerns relating to command implementation,
please contact your Sierra Wireless account representative.
Command access
Some commands in this reference are password-protected. To use
these commands, enter the correct password using AT
on page 26. Once the password is entered, all commands are
available and remain available until the modem is reset or powered
off and on.
is unique to each customer
and is configured onto the modem during manufacture. If you do not
know your password, contact your Sierra Wireless Account Manager
or Sierra Wireless distributor.
Command timing
Interval timing
Some commands require time to process before additional
commands are entered. For example, the modem returns
OK
when it
receives
. If
this, the modem returns an error.
