
Product Technical Specification & Customer Design Guidelines
46
Proprietary and Confidential - Specifications subject to change
2400058
4.7.4.1 Supported architectures
The AirPrime SL808X Embedded Module supports the following architectures
over the USB interface on Windows, Windows CE, and Linux systems:
•
Sierra Wireless Direct IP—Composite USB
•
Non-MUX—Composite USB
•
MUX (3GPP 27.010)—Composite USB (The MUX architecture is also
available over the UART interface.)
•
Non-MUX—Non-composite USB
For design requirements, see [6] AirCard/AirPrime USB Driver Developer’s
Guide.
The basic service configuration is PRI-dependent and may include the NDIS, AT,
and CnS services. The advanced service configuration (available for Windows
and Windows CE) is disabled by default, and may include the DM and PDP
services.
4.7.4.2 USB driver requirements
The host USB driver must meet each of these requirements:
•
Must act as a USB host device to interface with the module.
•
Must support remote wakeup, resume, and suspend operations as described
in Universal Serial Bus Specification, Rev 2.0, and
•
Must support serial port emulation. The module implements both 27.010
multiplexing and USB-CDC.
•
Should NOT send any SOF tokens (start-of-frames) to the module when there
is no valid data to send. These tokens keep the module awake and cause
unnecessary power consumption.
4.7.5 USB Suspend mode
When the module enters suspend mode, it shuts down the USB clock to save
power.
While in the suspend state:
•
Module provides signalling on the USB interface (USB_D+/USB_D-) to
indicate its current state to the host device.
•
VCC_3V6 must be maintained.
4.7.6 USB Resume mode
USB activity may be resumed by either the USB host or by the module:
•
Host-initiated:
a.
USB transceiver detects the change in bus activity and triggers the
USB_RESUME interrupt to the module's processor.
b.
Module enables its USB clock and responds to the host.
Summary of Contents for AirPrime SL808 Series
Page 1: ...Product Technical Specification Customer Design Guidelines AirPrime SL808X 2400058 Rev 1...
Page 2: ......
Page 122: ......