Sierra Wireless AirPrime Q26, User Manual

Page: 18 / 40

4117783 Rev 6.0 December 19, 2016 18
3. Pin Mapping
The following table lists the pin assignment mapping of the Q26 Carrier Board and the HL6528, HL6528RD and HL8548 modules (which are inserted in the
Snap-in Socket on the Carrier Board); as well as indicates restrictions or limitations on the signals/pins, if any.
The pin number specified in the table below refers to the corresponding pin number on the board-to-board connector (CN301) of the Q26 Carrier Board, while
signal names refer to the module’s signal name. For more information about module signal names, refer to the product technical specifications listed in
section 7.1 Reference Documents.
Table 9. Pin Mapping
CN301
Pin #
Q268xx Signal Name Q2698 Signal Name
Q26 Carrier Board with
HL6528, HL6528RD
Signal Name
Q26 Carrier Board with
HL8548 Signal Name
Compatibility Notes
1 ADC0/VBATT ADC0/VBATT VBATT_PA VBATT_PA
2 ADC0/VBATT ADC0/VBATT VBATT_PA VBATT_PA
3 ADC0/VBATT ADC0/VBATT VBATT VBATT
4 ADC0/VBATT ADC0/VBATT VBATT VBATT
5 VCC_1V8 VCC_1V8 VGPIO VGPIO
6 CHG-IN CHG-IN - - Not supported
7 BAT-RTC BAT-RTC BAT_RTC BAT_RTC
The HL8548 supports a
different voltage range
8 CHG-IN CHG-IN - - Not supported
9 SIM-VCC SIM-VCC UIM1_VCC UIM1_VCC
10 VCC_2V8 VCC_2V8 - -
11 SIM-IO SIM-IO UIM1_DATA UIM1_DATA
12 SIMPRES SIMPRES/GPIO18 UIM1_DET/GPIO3 GPIO3 / UIM1_DET
13 ~SIM-RST ~SIM-RST UIM1_RESET UIM1_RESET
14 SIM-CLK SIM-CLK UIM1_CLK UIM1_CLK
15 BUZZER0 BUZZER0 UIM2_RESET/BUZZER PWM1