6
Troubleshooting
“There is no tanning solution coming out of the spray gun”
1. Check there is enough solution in spray gun container.
2. Make sure the spray gun is not clogged up with old tanning solution. Follow Cleaning and
Maintenance instructions.
“Tanning solution is too runny”
1. Spray volume may be too high. It can be adjusted with the Solution Flow Screw (8) by turning it
>>
clockwise to reduce the amount of solution (Fig.2).
2. When spraying, hold the spray gun further away from your client’s body or move the spray gun
faster.
3. You may not be spraying evenly. Keep the spray gun moving and do not overlap those areas
already spray tanned.
“Tanning solution sprays irregularly”
1. The solution volume may be too low and this can be adjusted with the Solution Flow Screw (8)
>>
by turning anticlockwise until you get the desired volume (Fig.2).
“The tan is patchy”
1. Ensure your client has exfoliated before spray tanning.
2. Ensure you spray tan in a methodical way to cover all areas. It is easy to see which parts have
been sprayed. Keep the spray gun moving and do not overlap those areas already spray tanned.
3. Ensure that you spray tan lightly and in layers rather than one thick layer.
Fully Accredited Sienna X training available and Refresher Training available simply call
0800 131 3151 for more information.
Cleaning & Maintenance
Always wash out your spray gun at least at the end of each day. If the tanning solution dries inside
the spray gun, cleaning will become more difficult and the spray gun may become inoperable.
To wash out your Spray Gun
●
Switch off and disconnect the motor unit from mains supply.
●
Unscrew the container from the main body of the spray gun.
●
Pour any excess solution back into its orginal container for future use.
●
Half fill the container with water and re-fit it to the spray gun main body, shake the spray gun
lightly, re-connect the motor unit to the mains supply and spray the water through the gun.
>>
Repeat several times until the water is clear with no traces of tanning solution.
●
Continue to spray the clean water until the container is empty. Run the spray gun for a further 2
minutes with just the air blowing through it. This will dry the inside of the spray gun preventing
any contamination of the working parts.
●
Clean any traces of tanning solution from the outside of the gun with a damp cloth.
●
Wipe clean the Container Seal (11) inside the lid of the spray gun.
