Siemens ZIEHL TR 1200, Operating Manual

Page: 10 / 20

Edited (Date / Name): 16.07.09 Ba/Su Drawing No.: 12320-0702-01
Page 10 von 20 Name: TR 1200
ZIEHL industrie-elektronik GmbH + Co KG, Daimlerstr.13, D-74523 Schwäbisch Hall, Tel.: +49 791 504-0, Fax: -56, e-mail: info@ziehl.de
8.8 Configuring the relay
Adjustment process:
•
Select the menu item with the Up/Down key until …
⇒
Display 8 rel.
rel. rel.
rel. 8 (Relay function)
•
Press the Set key
⇒
Display 8 rel rel rel rel 8 / 8 r r r r 8 (Relay function / Zero signal current) flash
alternately
•
Use the Up and Down keys to select the relay function
•
Press the Set key (exits the configuration mode)
⇒
Display 8 rel. rel. rel. rel. 8 (Relay function)
8.9 Configuring the RS485 interface
Adjustment process:
•
Select the menu item with the Up/Down key until …
⇒
Display 8 bus. bus. bus. bus. 8 (Bus)
•
Press the Set key
⇒
Display 8 prt prt prt prt 8 / 8 485 485 485 485 8 (Protocol / 485) flash alternately
•
Set the desired protocol using the Up and Down keys
•
Press the Set key
⇒
Display 8
adr
adr adr
adr
8
/
8
0
0 0
0
8 (Device address / Value) flash alternately
•
Set the desired device address using the Up and Down keys
•
Press the Set key
⇒
Display 8 bdr bdr bdr bdr 8 / 8 96 96 96 96 8 (Baud rate / Value) flash alternately
•
Set the desired baud rate using the Up and Down keys
•
Press the Set key
⇒
Display 8
par
par par
par
8
/
8
eve
eve eve
eve
8 (Parity / Value) flash alternately
•
Set the desired parity bit using the Up and Down keys
•
Press the Set key (exits the configuration mode)
⇒
Display 8 bus. bus. bus. bus. 8 (Bus)
Note:
The set device address always applies for the transmission of Sensors 1…6.
If at least one of the sensors 7…12 as is configured as 2- or 3-conductor
(not „nc“), they will be transmitted with the set device 1.
More information about Modbus configuration and programming can be found in
Appendix 1 (Download from www.ziehl.com )