![Siemens WT46W567GB Operating And Installation Instructions Download Page 2](http://html.mh-extra.com/html/siemens/wt46w567gb/wt46w567gb_operating-and-installation-instructions_378821002.webp)
8
Installation
Scope of delivery: dryer, installation and instruction manual, basket for woollens
(depending on the model).
Check dryer for transport damage.
The dryer is very heavy. Do not lift without assistance.
Be careful to avoid sharp edges.
Do not install in a room which is susceptible to frost. Water may cause damage once it
starts to freeze.
If in doubt, have the appliance connected by a specialist.
Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
Setting up the dryer
The appliance plug must always be accessible.
Ensure that the appliance is installed on a clean,
level and firm surface.
Do not obstruct the air inlet on the front of the
dryer.
Keep the area around the dryer clean.
Level the dryer using the threaded feet.
Use a spirit level.
Do not remove the threaded feet under any
circumstances.
Mains connection
see safety information
a
Page 13.
Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist.
The mains voltage and the voltage shown on the rating plate (
a
Page 10
) must be the
same.
The connected load and necessary fuse protection are specified on the rating plate.
Frost protection
Preparation
1. Empty the condensation container
a
page 4
.
2. Select any programme using the programme selector.
3. Press the
Start
/Stop button
a
condensation is pumped into the container.
4. Wait 5 minutes and then empty the condensation container again.
5. Turn the programme selector to
Off
.
Transport
Preparation of dryer
a
see Frost protection.
Transport the dryer in a vertical upright position.
Following transportation, leave the dryer to stand for two hours.
There may be residual water in the dryer.
This can leak out if the dryer is at an angle.
1.
Remove all accessories
from the drum.
The drum must be empty.
Make sure that the air inlet
remains unobstructed
Clean and level
Do not install the dryer behind a door or sliding
door, which could prevent or restrict opening of the
dryer door. This will prevent children from locking
themselves in and putting their lives in danger.
2.
Do not operate the dryer if
there is a danger of frost.
9
Only when the appliance is
switched off.
Care and cleaning
Heat exchanger
The heat exchanger of the dryer is cleaned automatically when drying is in progress,
Cln
appears in the display panel. Do not pull the condensation container out during the cleaning
process.
Dryer housing, control panel, air intake
Wipe with a soft, damp cloth.
Do not use harsh cleaning agents or solvents.
Remove detergent and cleaning agent residue immediately.
Some water may collect between the window and the seal during drying. This does not affect
the proper operation of your dryer in any way.
Filter in the condensation tank
The filter is cleaned automatically when the condensation container is emptied.
However, the filter should still be cleaned regularly under running water. This prevents stubborn
deposits/dirt from building up.
Cleaning is only required if the symbol
ā
flashes again in the display panel after the
condensation container has been emptied.
1.
Pull out the condensation container.
2.
Pull the filter out of its snap-in lock.
3.
Clean the filter under running water or in the dishwasher.
4.
Refit the filter.
5.
Insert the condensation tank so that it locks into place.
Only operate the dryer with the filter inserted.
Moisture sensor
The dryer is equipped with stainless-steel moisture sensors. These measure how damp the
laundry is. After long periods of use, a fine layer of limescale can form on the moisture
sensors.
1.
Open the door.
2.
Clean the moisture sensors using a damp sponge with a rough surface.
Do not use steel wool or other abrasive materials.
10
Technical data
ʠ
Dimensions (DxWxH)
60 x 60 x 85 cm (adjustable height)
Weight
approximately 53 kg
Max. capacity
7 kg
Condensation container
4.0 l
Connection voltage
220-240 V
Connected load
max. 1000 W
Fuse protection
10 A
Ambient temperature
5 - 35 °C
Product number
Production number
Inside of door
The rating plate can be found on the back of the dryer.
ʠ
Consumption rates
These are guide values determined under standard conditions.
Spin speed in rpm
(residual moisture)
Drying time
in min.**
Energy consumption
in kWh**
Cottons/Coloureds 7 kg
Cupboard Dry*
1400 (approx. 50 %)
112
1.35
1000 (approx. 60 %)
131
1.60
800
(approx. 70 %)
150
1.86
Iron Dry*
1400 (approx. 50 %)
80
0.96
1000 (approx. 60 %)
99
1.22
800
(approx. 70 %)
118
1.47
Easy-care 3.5 kg
Cupboard Dry*
800
(approx. 40 %)
51
0.56
600
(approx. 50 %)
63
0.70
*Test programme to DIN EN 61121
**The values may differ from those given, depending on overvoltage and undervoltage, the type of fabric, composition
of the laundry to be dried, the residual moisture in the fabric and the size of the load.
ʠ
Drum interior light (bulb E14, 25 W)
The drum is illuminated after the door is opened or closed, and after the programme has started. The light goes out
automatically. To change the bulb
a
page 12
.
Optional accessories
(order from the after-sales service using the order number)
Platform
For better loading and unloading. The basket contained in the drawer can be used to carry
the laundry.
Washer-dryer stack connection set
The dryer can be stacked on top of a suitable washing machine of the same depth and width,
to save space. The dryer
must
be secured to the washing machine with this connection set.
Same as WZ 20310, but with pull-out worktop.
Installation underneath the worktop
Instead of the appliance covering plate, you
must
have a metal cover fitted by a specialist.
WZ
20460
WZ
20310
WZ
20300
WZ
20290
11
Normal noises
During drying, the compressor and the pump generate some noise which is entirely normal.
The compressor in the dryer may
occasionally generate a droning noise.
The compressor in the dryer is ventilated
from time to time, which creates a whirring
sound.
The automatic cleaning process causes a
clicking noise.
The process of pumping the condensation
into the condensation container generates
pumping noises.
12
What to do if ...
If you cannot rectify a fault yourself, please contact our after-sales service. We will always find
an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
the manufacturer and rest assured that the repair will be carried out by trained service
technicians using original spare parts. The contact details of your local after-sales service can
be found in the enclosed
after-sales service
directory, or by calling one of these numbers:
GB
0844 8928999 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
IE
01450 2655
When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see the inside of the door).
Set the programme selector to
Off
and remove the appliance plug from the socket.
ʠ
The
Start
/Stop indicator lamp
does not light up.
Mains plug plugged in?
Programme selected?
ʠ
The
ā
symbol and
Start
/Stop
indicator lamp flash.
Empty container for condensation
a
see page 4
.
Clean the condensation container filter if necessary
a
Page 6
.
Each time the dryer is transported, you must wait two hours
before operating it.
ʠ
The
4
symbol and
Start
/Stop
indicator lamp flash.
Rinse the fluff filter under running water
a
Page 4.
ʠ
Dryer does not start.
Start
/Stop button selected?
Door closed?
Programme set?
Ambient temperature greater than 5 °C?
ʠ
Water is leaking out.
Make sure the dryer is level.
ʠ
The door opens by itself.
Push the door closed until you hear it click into place.
ʠ
Drying result was not achieved
(laundry too damp).
Hot laundry feels damper than it actually is.
The selected programme does not suit the load. Use
another drying programme or, in addition, select the time
programme
a
page7.
Use fine adjustment for the drying result
a
page1/2.
Fine layer of limescale on the humidity sensors
a
Clean
the humidity sensors
a
page 9
.
Programme cancellation, e.g. tank full, mains power supply
failure, door open or maximum drying time reached.
ʠ
Drying time too long.
Clean the fluff filter under running water
a
page 4.
Insufficient supply of air
a
ensure that air can circulate.
Air inlet possibly blocked
a
Clear inlet
a
page 8
.
Ambient temperature higher than 35 °C
a
Ventilate the
room.
ʠ
The humidity in the room
increases significantly.
Make sure the room is sufficiently ventilated.
ʠ
Cln
appears in the display panel. Not an error! Automatic cleaning of the heat exchanger.
Do not empty the condensation container.
ʠ
Power cut.
Remove the laundry from the dryer immediately and spread
it out. Heat may escape.
ʠ
The interior light is not working.
Unplug the appliance plug, fold back the cover cap on the
inside above the door (using a Torx 20 screwdriver) and
replace the bulb. Close the cover cap.
Never operate the dryer without a cover cap.
ʠ
Other intermittent noises and
vibrations.
Not an error!
Normal noises
a
Page 11
.
ʠ
Loud humming noise for several
seconds.
Has the condensation container been properly reinserted?
a
Push the condensation tank all the way in.
Not an error! Normal noises
a
Page 11
.
13
Safety instructions
Emergency
Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
dryer...
In rooms inside the house.
To dry fabrics.
The dryer must
NEVER...
Be used for purposes other than those described above.
Be modified in terms of its technology or properties.
Hazards
The dryer must not be used by children or persons who have not been
instructed in its use.
Do not leave children unsupervised near the dryer.
Keep pets away from the dryer.
Remove all objects from the pockets of garments.
Pay particular attention to cigarette lighters
a
Risk of explosion
Do not lean or sit on the door
a
Risk of tipping.
Installation
Secure loose cables
a
Tripping hazard.
Do not operate the dryer where there is a risk of frost.
Mains
connection
Connect the dryer according to specifications to an AC earthed socket,
otherwise it cannot be guaranteed that the appliance is completely safe.
The cable cross-section must be sufficient.
Only use earth-leakage circuit breakers with the following symbol:
The appliance plug and socket must be compatible.
Do not use multiple plugs/connectors and/or extension cables.
Do not touch or hold the appliance plug with wet hands
a
Risk of electric shock.
Never pull the appliance plug out of the socket by its cable.
Do not damage the mains lead
a
Risk of electric shock.
Operation
Only laundry must be loaded into the drum.
Before switching on the dryer - check the contents.
Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
cleaning solvent, etc.)
a
Fire/explosion hazard.
Hazard caused by dust (e.g. coal dust, flour): do not use the dryer
a
Risk of explosion
!
Do not put laundry containing foamed material/rubber in the dryer
a
elastic
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
Switch off the dryer once the programme has ended.
The water from condensation is not drinking water and may be contaminated
with fluff.
Defect
Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
Do not use a dryer with a faulty mains lead. To prevent risks, a faulty mains
lead must only be replaced by the after-sales service.
Before changing the bulb of the interior light make absolutely sure you have
pulled the appliance plug from the socket
a
Risk of electric shock!
Spare parts
Only use genuine spare parts and accessories for safety reasons.
Disposal
Dryer: unplug the appliance plug,
then
cut the mains lead from the appliance.
Dispose of the dryer at an approved public disposal facility.
The heat exchanger contains fluorinated greenhouse gas R-407C covered by
the Kyoto Protocol
a
dispose of in a proper manner. Capacity: 0.43 kg.
Packaging: keep all packaging out of reach of babies and children.
a
Danger of suffocation!
All materials are environmentally safe and recyclable. Dispose of in an
environmentally-responsible manner.
Operating
and installation instructions
en
Observe the safety
instructions on
page 13.
Read these instructions before switching
on the dryer.
Tumble dryer