Siemens WM16Y892AU, Instruction Manual And Installation Instructions

Page: 28 / 56

en
Operating the appliance
28
Measure and add detergent
and care products
For the majority of programmes on your
washing machine, detergent and fabric
softener are dosed automatically; it is a
factory setting for these programmes
and can be changed.
~
Page 16
In addition to intelligent dosing, you can
manually add cleaning aids (e.g.
softener, bleach or stain remover) to
compartment
À Á
, if necessary.
~
Page 34
For programmes without intelligent
dosing, or as desired (in which case,
set intelligent dosing to
ö
(off)),
detergent can be added manually to
compartment
À Á
.
~
Page 34
Start the programme
Make sure that no items of laundry are
trapped between the door and the
rubber seal, and close the door.
The main menu for the selected
programme is indicated again on the
display panel.
Press the
Ü
button to start the
programme.
During washing, the progress of the
programme is displayed in a bar on the
display panel. The bar fills in during the
washing cycle and provides information
about the current progress of the
programme.
The arrows fade in and out according to
the progress of the programme. They
indicate the programme settings/
options which can be changed/added
as the programme progresses.
Some programme sequence steps
explained:
■
Load adjust active
~
Page 36
■
Pre-washing, Washing, Rinsing,
Spin, Drain
... are displayed during
the wash cycle.
■
Extra rinse: foam
Note: Foam detection
If
Foam has been detected
also
appears on the display panel, the
washing machine has detected too
much foam during the wash
programme and has automatically
switched on one or more rinse
cycles in order to remove the foam.
Add less detergent to the next
washing cycle with the same load.
■
Other displays
~
Page 41
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
:HLWHUH3URJUDPPH
ƒ& K c
/RDGDGMXVWDFWLYH