en
Faults and what to do about them.
46
Faults and what to do about them.
Drum care information:
This instruction reminds you to carry out the
Drum Clean 90 °C
programme or
a 60 °C programme to clean and care for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent
foaming, only use half the amount of detergent recommended by the
detergent manufacturer. Do not use detergents designed for woollens or
delicates.
■
Switch reminder information on/off.
Other displays
Error E:XXX
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call the after-sales service.
Faults
Cause/remedy
Water is leaking from the
appliance.
■
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the inlet hose.
The appliance is not filling
with water.
■
Have you pressed the
Ü
button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
■
Is the inlet hose kinked or trapped?
The dispenser is empty
and the fill level indicator
is not flashing.
■
Is the drawer cover/connector dirty? Cleaning
■
Has the detergent drawer been pushed in correctly? Insert correctly.
The wrong detergent/
fabric softener has been
poured into the
dispenser(s).
Dispenser(s):
1.
Empty and clean.
2.
Refill.
Detergent/fabric softener
has congealed in the
dispensers.
Clean and refill the dispensers.
The door cannot be
opened.
■
The safety function is activated. Cancel the programme?
■
Is the
w
childproof lock activated? Deactivate.
■
Is
$
selected (Rinse Hold = no final spin)?
■
Can the door only be opened by the emergency release?
The programme will not
start.
■
Have you pressed the
Ü
or
Finish in
button?
■
Is the door closed?
■
Is the
w
childproof lock activated? Deactivate.
The drum briefly jerks or
judders after the
programme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder
briefly when the wash programme starts.
Display
Cause/remedy
