Siemens WM16XME2FG, User Manual And Installation Instructions

Page: 16 / 56

NL Set up and connect
3.
Loosen and remove the screws of
the horizontal transport
reinforcement with a T20
screwdriver.
2.
Connect the water inlet hose to the
tap (26.4 mm = 3/4").
3.
Open the tap carefully and check
that the connections are tight.
4.
Remove the transport
reinforcement.
Water drainage connection types
The information will help you connect this
appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
▶
Secure the water drain hose against
unintentional disconnection.
Remark: Observe the pumping
heights.
The maximum pumping height bed
4.6 Connecting device
Connect water supply hose
1.
Connect the water supply hose to
the appliance.
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
washbasin
the water drainage
feeding hose with
a bend
fixate and
gene.
16