Siemens WM16XKH0EU, Manual

Page: 61 / 72

Troubleshooting
en
61
Problem with results
Errors Cause Troubleshooting
Creasing. The spin speed is too high.
▶
The next time you run a wash cycle,
set a lower spin speed.
The load is too large.
▶
The next time you run a wash cycle,
reduce the amount of laundry being
loaded.
The wrong programme is se-
lected for the type of fabric.
▶
Select the programmes that are suit-
able for the type of fabric.
→
"Programmes", Page 24
The spin result is not satisfact-
ory. The laundry is too wet/too
damp. A low spin speed is selected.
▶
The next time you run a wash cycle,
set a higher spin speed.
Less Ironing
is activated.
▶
Select the programmes that are suit-
able for the type of fabric.
→
"Programmes", Page 24
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Detergent residue on the
damp washing. Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
▶
Start the
Rinse
programme.
Unsuitable detergent added to
the dispenser of the intelligent
dosing system.
1.
Check whether the detergent used is
suitable.
→
"Detergents and care products",
Page 34
2.
Drain the dispenser.
→
"Cleaning the detergent drawer",
Page 48
3.
Clean the dispenser.
4.
Refill the dispenser.
→ "Filling the dispenser", Page 39
Basic dosage is not correctly
adjusted.
▶
If intelligent dosing is activated, re-
duce the basic dosage
→ Page 40 .
Detergent residue on the dry
laundry. Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
▶
Brush out the laundry after washing
and drying.