Home Connect
en
45
Software update
Requirement:
The display shows
UdP
.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 6.
→
"Overview of Home Connect set-
a
UPd
appears on the display.
3.
Press
Start / Reload
.
a
The software update is installed.
a
If
End
is shown on the display, the
software update is installed.
Note:
The software update may take
several minutes. Do not switch off the
appliance while the software update is
in progress.
Connecting the appliance to
the energy manager
If you connect the appliance to the
smart energy system (energy man-
ager), you will optimise your energy
consumption. The appliance starts only
when your home photovoltaic system
can provide sufficient energy or the en-
ergy tariff is good.
Requirements
¡
The smart energy system (energy
manager) must use the EEBus Initiat-
ive communications standard.
¡
You have read about how to connect
your appliance to the smart energy
system (energy manager) in the in-
struction manual for the smart en-
ergy system (energy manager).
1.
Press and hold
Remote Start
for
approx. 3 seconds.
a
The display shows
Aut
.
2.
Set the programme to position 7.
→
"Overview of Home Connect set-
a
The display shows
EnG
.
3.
Press
Start / Reload
.
a
The appliance is connected to the
smart energy system (energy man-
ager).
a
If the appliance has connected to
the energy manager successfully,
the display shows and .
4.
Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→
"Activate Flex Start", Page 45
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to provide
sufficient energy or the energy tariff is
good.
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
- Finish in +
to set the re-
quired time.
3.
Press
Start / Reload
.
4.
Press
Start / Reload
.
a
The display shows and Flex Start
is activated. The appliance waits to
be started by the smart energy sys-
tem (energy manager).
a
If the time changes on the display,
e.g. to 8 h, the smart energy system
(energy manager) has established a
time at which your appliance can
start.
a
If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends. The
programme ends when the time
period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡
Press
Start / Reload
.
Summary of Contents for WM16XKH0EU
Page 54: ...en Cleaning and servicing 54 3 Connect the water inlet hose and check for leaks ...
Page 70: ......
Page 71: ......
