en
Positioning and connecting
50
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without
any laundry.
Notes
■
The washing machine
must be
correctlyinstalled
and
connected
.
(from
■
Never use a damaged machine.
Inform your customer services.
Preparatory work:
1.
Check the machine.
2.
Fill the
ß
and
i
dispensers.
3.
Remove the protective film from the
control panel.
4.
Connect the mains plug.
5.
Turn the tap on.
Run the programme without laundry.
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
Drum Clean
90 °C
programme.
4.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
compartment
À
Á
.
6.
Pour standard detergent into
compartment
À
Á
.
Note:
To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for woollens or delicates.
7.
Close the detergent drawer.
8.
Press the
Ü
button.
9.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
E.g. when moving house
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers.
Leaking detergent/fabric softener can
prevent the appliance from working
correctly, e.g. due to damage to the
electronics.
Empty the dispensers before
transporting the appliance.
Preparatory work:
1.
Turn off the tap.
2.
Reduce the water pressure in the
and maintenance – filter in the water
supply clogged
3.
Disconnect the washing machine
from the mains.
4.
Drain any residual water:
maintenance – drain pump blocked,
emergency draining
5.
Remove the hoses.
6.
Empty the dispensers.
