Siemens WM14VM69GR, User Manual And Installation Instructions

Page: 53 / 68

Troubleshooting
en
53
Fault Cause and troubleshooting
"E:30 / -80"
▶
Remove any unapproved extensions from the water
hose. Connecting the appliance
"E:36 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 46
"E:38 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drum", Page 44
if the fault is displayed again,
▶
→ "Cleaning the drain pump", Page 46
Inlet opening of the rubber gasket is blocked.
▶
→ "Cleaning the intake opening in the rubber gas-
ket", Page 48
⁠ The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow → Page 49 .
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
⁠ Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
⁠ lights up. The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 40
Water level is too high.
▶
Start the
Άντληση
programme.
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
Έναρξη Προσθήκη ρούχων
to start the pro-
gramme.