Troubleshooting
en
33
Fault
Cause and troubleshooting
"E:30 / -80"
▶
Ensure that the pump cap is screwed in all the way
into the appliance. The handle on the pump cap
must be in a vertical position.
→
"Cleaning the drain pump", Page 31
"E:36 / -25 / -26"
Drain pump is blocked.
▶
"Cleaning the drain pump", Page 29
"E:60 / -2B"
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
Water level measurement system is defective.
▶
Call the after-sales service.
→
Voltage under-usage
symbol (double point).
The automatic voltage control system detects an un-
authorised voltage under-usage.
▶
No remedial action possible.
Note:
If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
flashes.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up.
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 27
Water level is too high.
Summary of Contents for WM10J18SZA
Page 43: ......
