Siemens WM N Series, Manual

Page: 29 / 44

Operating the appliance
en
29
Changing the programme
default settings
You can use the default settings or
change them.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The settings are activated without
needing to be confirmed.
They are not saved when the appliance
is switched off.
~
"Programme default settings"
on page 26
Overview of programmes
~
Supplementary sheet for the operating
and installation instructions.
Selecting additional
programme settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The indicator lamp for the button lights
up if a setting is active.
The settings are not saved when the
appliance is switched off.
~
"Additional programme settings"
on page 27
Overview of programmes
~
Supplementary sheet for the operating
and installation instructions.
Placing laundry into the drum
:
Warning
Risk of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse items of laundry thoroughly
beforehand.
Notes
■
Mix items of laundry of varying sizes.
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual items of
laundry may lead to imbalances.
■
Observe the specified maximum
load. Overfilling has a negative
impact on the washing result and
promotes creasing.
1.
Place presorted items of laundry
unfolded in the washing drum.
2.
Make sure that no items of laundry
are trapped between the washing
machine door and the rubber seal,
and close the door.
The
I
button indicator lamp flashes to
indicate that the washing programme
can be started. It is possible to change
the settings.
~
"Programme default settings"
on page 26
~
"Additional programme settings"
on page 27
www.devicemanuals.eu/