Additional programme settings
en
27
3.
Press the
I
button.
The door will be locked.
The selected number of hours (e.g.
‰
h
) is shown in the display panel
and counts down until the wash
programme starts. The duration of
the programme is then displayed.
Note:
The programme duration is
included in the selected “Ready in”
time.
During the timer count-down
, you can
change the preselected number of
hours as follows:
1.
Press the
I
button.
2.
Use the
Ready in
button to change
the number of hours.
3.
Press the
I
button.
During the timer count-down
you can
add or remove laundry as required.
Note:
The length of the programme is
automatically adjusted when the
programme is running.
Certain factors can affect the
programme length, e.g.:
■
Programme settings,
■
Detergent dosage (additional rinse
cycles if required due to foaming),
■
Load size/type of textiles (longer
washing for higher load and for
textiles which absorb more water),
■
Imbalances (e. g. due to fitted
sheets) are offset with several start-
ups of spin cycles,
■
Fluctuations in power supply,
■
Water pressure (infeeding speed).
\
Additional programme
settings
Additional programme settings
The available settings vary depending
on the model.
You can find an overview of all settings
available for selection in each
programme on the supplementary sheet
for the operating and installation
instructions.
speed eco
(
(
¦
,
(
speedperfect,
¦
ecoperfect,
speed eco)
Button with two possible settings for
adapting the selected programme:
■
speed
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more
energy than, the selected
programme, without the speed
setting.
Note:
Do not exceed the maximum
load.
■
eco
Energy-optimised washing by
reducing the temperature and
increasing programme duration
while achieving a washing result that
is consistent with the selected
programme, without the eco setting.
If you press the
speed eco
button once,
you select the
speed
setting. If you
press the button again, the
eco
setting
is activated. The respective symbol is
shown in the display when the setting is
activated. If you press the button again,
no setting is activated.
www.devicemanuals.eu/
