22
Detergent residues on the
washing.
Some phosphate-free detergents
contain water-insoluble residues which
appear on washing as light specks.
Rinse the laundry again or change to
using liquid detergent. Brush the
laundry after it has dried.
Grey residues on the
washing.
Soiling caused by ointments, grease or
oil.
Wash the laundry using the maximum
detergent dosage and the maximum
permissible temperature – see the
care label.
Programme terminated
unexpectedly.
The
M
(
Start/
Pause) button was
selected accidentally.
Press the button again to restart the
programme.
Spinning during drying
No fault
"Thermo spin", which is for energy-effi-
cient drying, starts after a drying time
of approx. 10 minutes.
Drying result not
satisfactory.
The laundry clings to the sides of the
drum after being spun.
Loosen up the laundry by hand,
start the drying programme
–> page
16.
Closed tap
Turn on the tap.
Selected drying time too short.
Select the drying time according to the
load size.
Maximum or minimum load not taken
into account –> page
30.
Once the programme has ended:
adjust the load quantity, select a
suitable drying programme and restart.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment
i
.
The fabric softener compartment insert
is not correctly attached or is blocked.
If necessary, clean the fabric softener
compartment insert and fit it correctly
in
compartment
i
.
The laundry is not dried
.
The tap is turned off.
Turn on the tap.
The load is too large.
Reduce the load size.
The drying time is too short.
Select a suitable drying time.
No display on the display
panel.
Power cut.
The programme continues when power
is restored. If you wish to remove the
laundry during a power cut, you must
first drain out the water –> page
19.
Check whether:
- the plug is plugged into the socket
correctly
-the circuit breaker (fuse) has tripped;
call the after-sales service.
–> page
24.
Door cannot be opened.
$
(Rinse hold)
has been selected.
Select the programme
Empty
t
+ Spin
B
and press
M
Start/
Pause.
The programme is running or the door
is locked for safety reasons.
Wait until
appears on the
display panel.
Power cut.
Unlock the door mechanically.
