Positioning and connecting
en
19
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean
k
programme the first
time
without
laundry.
Note:
■
The appliance must have been
installed and connected properly.
■
Never switch on a damaged
appliance.
1.
Insert mains plug.
2.
Turn the water tap on.
3.
Close the door. Do not load any
laundry.
4.
Select the
Drum Clean
k
90°C
programme.
5.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
dispenser II.
7.
Add standard detergent to dispenser
II according to manufacturer’s
instructions for light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
8.
Close the detergent drawer.
9.
Select
I
Start/Reload
.
10.
When the programme ends, turn the
programme selector to
Û
(Off)
.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
3.
Drain any residual water.
4.
Disconnect the appliance from the
mains.
5.
Remove the hoses.
6.
Empty the dispensers.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Note:
Use a screwdriver if
necessary.
