Faults and what to do about them
en
33
Compartment
M
is not
rinsed out completely.
Remove the insert. Clean the detergent drawer and reinsert it.
Odour formation in the
washer dryer.
■
Run the
Fluff Clean
90°C
programme without laundry and detergent.
■
Use appropriate detergent for daily washing.
■
keep the door and detergent dispenser open after using.
Status display
o
is on.
Foam may come out of
the detergent drawer.
Too much detergent used?
■
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser
II
. (Not for outdoor, sports and down-filled textiles!)
■
Reduce detergent dosage for the next wash cycle.
■
Use commercially available low foam detergent and care products which
are suitable for washer dryers.
Excessive noise, vibra-
tions and “wandering”
during the spin cycle.
■
Appliance aligned? Align the appliance.
~
Page 41
■
Appliance feet fixed? Secure appliance feet.
~
Page 41
■
Transportation bolts are removed? Removing the transportation
bolts.
~
Page 38
Display panel/indicator
lights do not function
while the appliance is run-
ning.
■
Power failure?
■
Fuse tripped? Switch on/replace fuse.
■
If the fault occurs repeatedly, call customer service.
~
Page 35
The programme duration
changes during the wash
cycle.
■
Not a fault – unbalanced load detection system adjusts imbalance.
■
Not a fault – foam detection function active. Additional rinse cycle.
Detergent residue on the
laundry.
■
Occasionally phosphate-free detergents contain water-insoluble residue.
■
Select
Rinse
or brush items when the laundry is dry.
Spin noise during the dry-
ing phase.
This is an innovative process known as thermal spinning used to reduce
energy consumption during the drying phase.
Fluff found on the washed
laundry.
Run the
Fluff Clean
Ž
(cold) programme without laundry and detergent to
remove fluff which have accumulated inside the drum during the previous dry-
ing cycle.
Water inlet noise during
the drying phase.
The washer dryer uses water condensation technology, water is constantly
needed to dry the laundry. Therefore the tap must be on all the time, till the end
of drying phase.
Drying duration extended.
■
Run the
Fluff Clean
Ž
(cold) programme to remove fluff which has col-
lected in the washer drum during the drying phase.
Drying programme does
not start.
■
Drying programme not selected? Overview of programmes
~
Page 20
■
Door not closed properly?
Faults
Cause/Remedy
