en
Home Connect
48
5.
Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→
"Activate Flex Start", Page 48
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
Finished in
to set the re-
quired time.
3.
Press
Start / Reload
.
a
The display shows
Delayed start
.
4.
Press
Remote Start
.
a
If the display shows
Flex Start
,
Flex Start is activated and the ap-
pliance waits to be started by the
smart energy system (energy man-
ager).
a
If the display changes to
: Ready
in approx.
, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a
If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡
Press
Start / Reload
.
¡
Open the door.
¡
Switch off the appliance.
¡
Power failure.
Activating Wi-Fi on the appli-
ance
Note:
When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Select
Wi-Fi on/off
.
3.
Select
on
.
a
Wi-Fi is activated.
Note:
If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Deactivating Wi-Fi on the ap-
pliance
1.
Press and hold
Remote Start
for
at least 3 seconds.
2.
Select
Wi-Fi on/off
.
3.
Select
off
.
a
Wi-Fi is deactivated
Note:
If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement:
The display shows
A
new software version is available.
Do you want to update the software
now? This may take several
minutes.
.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Select
Software update
.
3.
Select
Install now
.
a
The software update starts.
