It has a flexible rubber seal. Simply
apply pressure with the tip of the screwdriver
to release the thread toward the tap´s
adjusting screw. Fig. 9.
If the cooking hob is to be installed above
to the assembly manual.
ventilation, and check the dimensions
according
an oven, check that the oven is fitted with
power
If no oven is installed under an
electrical or
mixed
(gas and electric) hob, place a
separator of non-flammable material e.g.
plywood or metal at a distance of 10 mm.
from the bottom of the hob to prevent access
to the lower part of the hob.
If no oven is installed under a
gas
hob, it is
suggested to place a separator of non-
flammable material e.g. plywood or metal at
a distance of 10 mm. from the bottom of the
hob to prevent access to the lower part of the
hob.
In the event that a drawer is located beneath
the appliance, please make sure that the
drawer contains no heat-sensitive or easily
combustible objects, such as spray cans or
shoe polish. Use a heat-resistant utility drawer
only.
3 -
tends to swell quite quickly when it comes into
treating the cut edges with a special glue, to
Depending on the model, the clips and the
watertight seal (lower edge of the cooking hob)
The seal ensures that the entire work
may already be fitted; if this is the case, do not
seepage.
If this item has not been fitted in the factory,
remove the pan supports and the gas burner
covers and diffusers from your cooking hob,
adhesive seal supplied with the appliance
Fig. 3a/3b,remove the clips from the attached
remove them under any circumstance.
accessories bag and screw them into the lower
surface will be watertight, and prevents water
and turn it upside down.Fig. 2. Now fit the
Once the hob is fitted you should turn the clip
onto the lower edge of the cooking hob,
For disassembly, unscrew the clip and
points designed for this purpose, Fig. 4a.
2- The chipboard used to make the worktops
protect them from steam or any condensation
contact with moisture. Thus we recommend
that might drip down beneath the cooker
unit's work surface.
and tighten the screw as shown in Fig. 4b.
Press down on the hob edges to ensure
proceed in the reverse manner.
round Fig. 5.
All installation, regulation and adaptation to
other types of gas must be carried out by an
authorised installation technician,
respecting all applicable regulations,
standards and the country's electrical and
gas supply companies' specifications.
It is recommended that you call our
Technical Assistance Service for adaptation
to other types of gas. Before you begin, turn
off the appliance's electricity and gas supply
.
All installation, regulation and adaptation to
other types of gas must be carried out by an
authorised installation technician,
respecting all applicable regulations,
standards and the country's electrical and
gas supply companies' specifications.
It is recommended that you call our
Technical Assistance Service for adaptation
to other types of gas. Before you begin, turn
off the appliance's electricity and gas supply
.
en
(see
table I).
(see table II)
that the cooking hob is supported all the way
(20,955 mm)
(L min. 1m - max. 3m).
(fig. 10):
Summary of Contents for VVK26G2120
Page 1: ...55 55 480 5 5 26 19 17 6 18 5 en fr ...
Page 2: ...a a b b ...
Page 3: ...Ø max 12 4 ...
Page 4: ...10 ...
