Siemens TK 91 N 01, Operating Instructions Manual

Page: 26 / 40

22
Messages in the display
Please
and
fill water
flash alternately in the display
The water tank 5 is empty.
Fill it with fresh water.
Press button
e
(small cup) and allow water to run into
a cup.
Ready
appears in the dispay again
Empty
and
capsules
flash
alternately in the display
The capsule container 13 is full.
Dispose of the used Nespresso® capsules (Fig. 6).
Check
and
container
flash
alternately in the display
The drip tray 12 and the capsule container 13 are
missing.
Put the drip tray 12 and the capsule container 13 back
into position.
The display shows
Power
save
The appliance automatically switches to power save if
it has not been used for an hour.
Visual alert
The float in drip tray 11 or 12
repectively becomes visible.
During the rinsing procedure, when preparing coffee
and drawing steam, a certain amount of water will
collect in the drip trays. As soon as these are full, the
float rises (Fig. 6). Once the float becomes visible, the
corresponding drip tray must be emptied.
● Remove the small drip tray 11
● Pull the large drip tray 12 forwards.
● Remove the capsule container 13 .
● Empty the drip trays and clean them using a little
detergent solution.
● Mount the capsule container 13 on the large drip tray
12 , and push back into position.
● Insert small drip tray 11 .
What if something goes wrong?
The blue illuminated ring 1b
does not light up.
Check the power supply (possible power outage) and
that the ON/OFF switch 17 is set to I .
It is impossible to heat water
or generate steam.
Nozzle 10 is blocked up.
Clean nozzle 10 using a detergent solution and a
blunt needle.
Not enough milk froth is being
produced, or it is too runny.
● The frothing attachment 9 is blocked. Wash with a
mild detergent solution, as directed.
● Use cold milk with a fat content of at least 1.5 %.
Message in display
Please fill water
despite a full water tank
After the water tank has been filled, no coffee has yet
been served.
Press
g
(hot water).
en