Siemens T1000, Administration Manual

Page: 28 / 88

6 SPARC Enterprise T1000 Server Administration Guide • April 2007
from SSH to Telnet. Up to eight simultaneous connections to the system controller
sc>
prompt are available through the network management port. For more
information, see “Activating the Network Management Port” on page 7 .
Accessing the System Controller
The following sections describe ways of accessing the system controller.
Using the Serial Management Port
When you are accessing ALOM CMT using a device connected to the system
controller’s serial management port, you will see the output of the ALOM CMT
diagnostics when AC power is first applied or when the system controller has been
reset. After the diagnostics have completed the serial management port is available
for login.
For more information about the system controller card, refer to the ALOM CMT
guide for your server.
▼
To Use the Serial Management Port
1. Ensure that the serial port on your connecting device is set to the following
parameters:
■
9600 baud
■
8 bits
■
No parity
■
1 stop bit
■
No handshaking
2. Establish an system controller session.
For instructions on how to use the system controller, see the ALOM CMT guide for
your server.