User Access Via the Keypad
86
Siemens Building Technologies
Fire Safety & Security Products
09.2008
11
User Access Via the Keypad
The following functions are available to users by entering their user code; these
functions do not require menu navigation on the Keypad. User codes can be 4, 5,
or 6 digits, depending upon the Grade the system has been programmed to.
A user’s ability to see menus and options available on the SPC system is
programmed by the installation engineer. If users cannot see an option described
in this manual, they do not have rights to access that functionality. For security
reasons, users code appear as asterixes on the display. The left function key
displays the QUIT option.
After entering the user code, the following options are displayed: FULLSET,
PARTSET A, PARTSET B, MENUS. Scroll through these options by using the
up/down arrow keys.
11.1 Setting the System: FULLSET
The FULLSET option provides the following functionality:
z
Full protection to a building (opening of alarm zones activates alarm)
z
Opening of entry/exit zones starts the entry timer. If the alarm is not unset before
the entry timer expires, the alarm is activated
To select the FULLSET option, enter a valid user
code, and press SELECT (right soft key). The
second line displays the exit time and the buzzer
sounds to indicate that the user should exit the
building. When the system has been fully set, the
LCD displays FULLSET on the bottom line for
approximately 10 seconds.
If the alarm fails to set, see Section 11.4, Failing to Set the System.
11.2 Setting the system: PARTSET A
The PARTSET A option provides the following functionality:
z
Perimeter protection to a building while allowing
free movement through the exit and access
areas
z
Exclusion of EXCLUDE A zones from protection
z
Instant activation of alarm on selection of mode;
by default there are no exit times associated with
PARTSET A
To select PARTSET A, enter a valid user code, scroll to the PARTSET A option
and press SELECT (right soft key).
If the alarm fails to set, see Section 11.4, Failing to Set the System.
18/07/2008 12:30
SETTING 45 SECONDS
18/07/2008
SYSTEM FULLSET
...PARTSET A?...
EXIT
SELECT
18/07/2008 12:55
PARTSET B SET
