en
Rinse aid system
26
1.
Press the catch on the lid of the
dispenser for rinse aid and lift
.
1
2
2.
Add rinse aid up to the max mark.
max
3.
If rinse aid spills out, remove it
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
4.
Close the lid of the dispenser for
rinse aid.
a
The lid clicks into position.
Setting the amount of rinse
aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
1.
Press .
2.
To open the appliance settings,
press
for 3 seconds.
a
flashes in the display.
3.
Press
repeatedly until
flashes.
4.
Press
repeatedly until the
right amount of rinse aid has been
set.
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
The factory setting is level 2 ("LED
A and LED B" →
).
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
5.
To save the settings, press
for 3 seconds.
Switching the rinse aid sys-
tem off
If you find the rinse aid refill indicator
irritating, e.g. when using combined
detergents with a rinse aid compon-
ent, you can switch the rinse aid sys-
tem off.
Tip:
The function of rinse aid is lim-
ited with combined detergents. You
will generally get better results using
rinse aid.
1.
Press .
2.
To open the appliance settings,
press
for 3 seconds.
a
flashes in the display.
3.
Press
repeatedly until
flashes.
4.
Press
repeatedly until no
lights up (level
0).
5.
To save the settings, press
for 3 seconds.
a
The rinse aid system is switched
off and the rinse aid refill indicator
is deactivated.
