SMD 18101 CS / SMD 18101 CP / SMD 18101 D
Instruction Manual, 11/2005, A5E00472377A-002
4-1
Application planning
4
4.1
Installation site
Provide adequate ventilation
Ventilation slots are located on the housing base, the rear panel and the side panels.
The distance at the rear must be at least 10 cm from a wall or 15 cm from other units.
Observe the permissible ambient temperature range
The unit must not be operated outside the permissible ambient temperature range.
Installation on a desk
The unit must be screwed onto a stand and installed on a hard horizontal surface (unit stand
for SMD 18101 CS/CP can be ordered separately). Only the stands recommended by the
manufacturer may be used.
Avoid reflections on the screen
The display has an anti-glare surface which is only effective with a clean, grease-free
screen. If the screen surface is dirty, clean it using a suitable microfiber cloth.
The display should be positioned so that reflections from lights, windows, furniture with shiny
surfaces or light-colored walls do not appear on the screen.
In order to reduce mirroring on the unit, only use non-dazzling reflector lights for the ceiling
lighting.
Change of environment
If the unit is brought into a warm environment from a cold one, condensation may form in the
unit. The unit should not be switched on until all the condensed water has evaporated,
including that inside the unit. This may take several hours, depending on the conditions.
See also
Safety notes (Page 2-1)
Climatic conditions (Page 11-5)
Cleaning (Page 9-1)
