Siemens Building Technologies, Ltd.2 Kenview BoulevardBrampton, Ontario L6T 5E4
P/N 315-049692C-1
Page 1: ...sitive module Refer to Figure 1 for the location of the two input terminals and two output terminals Line 1 and Line 2 can be either line of the loop The SLIM may be used in two circuit configurations as follows Class B See Figure 2 In Class B wiring each SLIM isolates a branch on the circuit Note that a short on the main branch causes the entire loop to fail To prevent this mount the SLIMs at the...
Page 2: ...ll more than 15 SLIMs per FDLC loop 6 All circuits are supervised 7 Refer to FDLC Installation Instructions P N 315 447360FA or the FS 250C Manual P N 315 049589C for the list of compatible devices as applicable 8 All terminals are power limited 1 All wiring must comply with national and local codes 2 In order to provide adequate protection it is recom mended that you do not install more than 20 d...
Page 3: ...al box that is 2 1 8 inches deep Connect the field wiring Press the SLIM into the box and fasten the module plate to the box Cover the module front plate with the plate supplied and fasten with screws supplied ELECTRICAL RATINGS Input power 24 VDC 1mA max SWITCHPLATE 4 INCHES SQUARE SUPPLIED SWITCHPLATE SUPPLIED 4 INCHES SQUARE 4 INCH SQUARE BOX 2 1 8 INCHES DEEP DOUBLE GANG BOX 3 1 2 INCHES DEEP ...
Page 4: ...Siemens Building Technologies Ltd 2 Kenview Boulevard Brampton Ontario L6T 5E4 P N 315 049692C 1 ...
