Siemens SIWAREX FTA, Device Manual

Page: 128 / 207

Weighing Functions
SIWAREX FTA
5-116
Name Type Address Range of Values / Explanation Reference
Statistic data
Total number of
weightings
DINT DBD000 Number of weighing procedures (with and
without tolerance check)
Number of control weighs DINT DBD004 Number of weighing procedures with
tolerance check
Number of weighing
procedures over TO2
DINT DBD008 Number of weighing procedures with
tolerance check over tolerance limit TO2
No. weigh procedures over
TO1
DINT DBD012 Number of weighing procedures with
tolerance check over tolerance limit TO1
Number of weighing
procedures good
DINT DBD016 Number of weighing procedures with
tolerance check within tolerance limits TU1
to TO1.
No. weigh procedures
under TU1
DINT DBD020 Number of weighing procedures with
tolerance check under tolerance limit TU1
No. weigh procedures
under TU2
DINT DBD024 Number of weighing procedures with
tolerance check under tolerance limit TU2
Number of weighing
procedures bad
DINT DBD028 Number of weighing procedures with
tolerance check outside tolerance limits TU2
or TO2
Reserve 0 DINT DBD032 Reserve 0
Reserve 1 DINT DBD036 Reserve 1
Set weight REAL DBD040 Current set weight (calibratable numeral
step,
with AWI application and country code
“OIML” rounded to the corresponding
numeral step)
Average value of net
weight
REAL DBB044 Average value of the net weights checked
for tolerance errors
Standard deviation of net
weights
REAL DBB048 Standard deviation of the net weights
checked for tolerance errors
Performance per hour REAL DBB052 Performance per hour [e.g. g/h, kg/h or t/h]
is projected based on the net weight of the
last weighing procedure.
Weighing procedures per
hour
INT DBW056 Weighing procedures per hour projected
based on the last weighing procedure (time
for one weighing cycle).
58
Table 5-22 DR 32 Allocation
5.21.1 DR 32 - Total number of weighing procedures
Number of weighings since the last statistic data deletion. The number of single fills
is determined in all operating modes.
5.21.2 DR 32 - Number of control weighs
The number of weighings in which a tolerance check has been performed. In
operating modes with totalizing (AWI totalizing and AWI gravimetric big bag),
the total loadings are counted.