Operate
6.2 Parameter description
SITRANS P500 with HART
108
Operating Instructions, 12/2014, A5E02344528-09
"2.4.3.4 Offsetsum"
Purpose:
Display zero offset total
Description:
The parameter indicates the total of the position error correction and the
sensor trim.
See also
"2.1.3.1 Perform Trim" (Page 85)
"2.4.3.2 Lower Sensortrim" (Page 107)
6.2.3.5
"2.5 Display"
"2.5.1 1. Display Value"
The first display value is the value that you selected in the "2.1.1 PV Select" (Page 83)
parameter .
The selection of the following parameters is dependent on the first display value:
●
"2.5.2 2. Display Value" (Page 110)
●
"2.5.3 3. Display Value (Page 113)
●
"2.5.4 4. Display Value" (Page 115)
"2.5.1.1 PV Scaling"
Note
Only if this parameter is set to "On" are the following parameters "2.5.1.2 Scaling LRV"
(Page 109) to "2.5.1.4 Scaling Unit" (Page 109) displayed.
This scaling affects only the display of the PV on the screen and not the output current.
Factory setting:
Off
Adjustment range:
•
Off
•
On
Purpose:
Activation of the LCD scaling
Description:
This parameter permits scaling of the value indicated in the display. You can
assign it any unit consisting of 5 characters.
Summary of Contents for SITRANS P500
Page 1: ......
Page 2: ......
Page 10: ...Table of contents SITRANS P500 with HART 10 Operating Instructions 12 2014 A5E02344528 09 ...
Page 238: ......