Siemens SITRANS 3100HT, Quick Start Manual, Page: 2 / 15

2
Order no.: A5E02451851-01
Quick Start MAG 3100 / 3100HT / 3100P / 5100W
Before installing, including in hazardous areas, refer to the operating instructions on the enclosed CD-ROM.
It contains detailed safety regulations, information and specifications which must be observed when
installing. Changes can occur. Documentations and approvals can be found on the Internet at
www.siemens.com/flowdocumentation.
Caution!
Correct, reliable operation of the product requires proper transport, storage, positioning and assembly as
well as careful operation and maintenance. Only qualified personnel should install or operate this instrument.
General instructions
CH
For safety reasons it is important that the following points are read and understood before the
installation of the equipment:
• Installation, connection, commissioning and service must be carried out by personnel qualified and
authorized to do so.
• It is the responsibility of the customer that the instructions and directions provided in the Quick Start and
in the operating instructions on the enclosed CD-ROM are read, understood and followed by the relevant
personnel before installing the equipment.
• It is the responsibility of the customer to instruct and authorize personnel to operate the equipment.
• It is the responsibility of the customer to ensure that the measuring system is connected correctly and is
in accordance with the connection diagram.
• Equipment used in hazardous areas must be Ex-approved and marked for Europe, FM for USA and CSA for
Canada. It is required that the special conditions for safe use provided in the manual and in the Ex
certificate are followed!
• Installation of the equipment must comply with national regulations. For example EN 60079-14 for the
European Community.
• Repair and service must be carried out by approved Siemens Flow Instruments personnel only.
Safety instructions
CH