SIPLUS CMS2000 Shield Support
6AT8002-4AA00
Compact Operating Instructions
English
Technische Änderungen vorbehalten. Zum späteren Gebrauch aufbewahren.
Subject to change without prior notice. Store for use at a later date.
© Siemens AG 2011
Technical Assistance
:
Telephone: +49 (0) 911-895-7222 (8°° - 17°° CET)
E-mail: [email protected]
Internet: www.siemens.de/automation/support-request
Siemens AG
Division Digital Factory
Breslauer Straße 5
90766 Fürth
GERMANY
SIPLUS CMS2000 shield support; for correct EMC connection of
signal and encoder cables to the basic unit VIB.
Additional strain release of the cables is required.
WARNING
These instructions as well as the operating instructions must be read and
understood before installation, operation or maintenance of the SIPLUS
CMS2000.
The product/system belonging to this documentation may only be
handled by personnel qualified for the respective task in hand, paying
attention to the SIPLUS CMS2000 operating instructions
(http://www.siemens.com/automation/service&support), in particular the
safety and warning notes contained therein.
Qualified personnel are those who, based on their training and experience,
are capable of identifying risks and avoiding potential hazards
when working with these products/systems.
Contents
• 5 clamp connections
• 2 shielding clips
• Compact Operating Instructions
Mounting the shield support
6WUDQGVPP
)XQFWLRQDOJURXQG
VWDUSRLQW
6KLHOGLQJEUDLG
6KLHOGVXSSRUW
7HUPLQDOFODPS
/$1(WKHUQHW
$QDORJLQSXWV
6HQVRUVLJQDOV
)XQFWLRQDOJURXQGLQJ
Note
Only connect functional ground using the designated
connections.
Attaching the cable shield
The following SIPLUS CMS2000 signals must be connected via
shielded
cables with their shields attached to the CMS2000
side:
• Sensor signals (VIB1 / VIB2)
• Analog inputs (AI1 / AI2)
• LAN (Ethernet)
The shields of the cables must be attached to the upper and/or lower
shield support using the clamp connections. To do this, proceed as
follows:
1. Strip the cable.
Sensor signals (VIB1 / VIB2), analog inputs (AI1 / AI2)
10 mm
≤
150 mm
1)
20 mm
LAN (Ethernet)
≤
150 mm
1)
20 mm
1)
Length depends on distance between shield support and device.
2. Press the clamp connection onto the protective braided shield of the cable.
3. Slide the clamp connection onto the shield support.
4. You can see the result in diagram 1 under "Mounting the shield support".
Note
Attach the cable shield on the device side no further than 15 cm away from
the input terminal.
Note
To ensure fault-free operation, particularly with long cables,
it is recommended to make a large area contact to ground potential for the shield
at the far end of the cable as well. Ensure adequate equipotential bonding.
Additional documentation
The SIPLUS CMS2000 Operating Instructions can also be found on the Internet
(http://support.automation.siemens.com/WW/view/en/56901901)