Cycles
9.3 Programming cycles
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
159
9.3.2
Error messages and error handling
9.3.2.1
General information
If error conditions are detected in the cycles, an alarm is generated and the execution of the
cycle is aborted.
The cycles continue to output messages in the dialog line of the control. These message will
not interrupt the program execution.
Reference
For more information on errors and required responses, as well as messages output in the
controller's dialog line, please refer to the SINUMERIK 802D sl Diagnostics Manual.
9.3.2.2
Error handling within cycles
Alarms with numbers between 61000 and 62999 generated in the cycles. This range of
numbers, in turn, is divided again with regard to alarm responses and cancel criteria. The
error text that is displayed together with the alarm number gives you more detailed
information on the error cause.
Alarm number
Clearing
criterion
Alarm Response
61000 ... 61999
NC_RESET
Block preparation in the NC is aborted
62000 ... 62999
Clear key
Program execution is not interrupted; display only