To extract the load securing device, proceed as follows:
1. Remove the retaining straps.
2. Remove the spacers such as wooden wedges, air cushions, etc.
4.5.3
Lifting the cabinet off the transport pallet
Use a crane to lower the transportation units from the transport pallets and transport them to
the installation site. Observe the guidelines described in the section "Transport with a crane."
4.5.4
Checking the shock and tilt indicators inside the cabinet.
Shock and tilt indicators are also located inside the cabinet. Check these as soon as you have
unpacked and opened the device. To perform the check, proceed as described in "Checking
shock and tilt indicators"
NOTICE
Material damage caused by shipping indicators remaining in the device during operation
During operation, the shipping indicators can become detached and fall into the device as a
result of high temperatures. Material or temperature damage may result.
• Remove the shipping indicators before commissioning. Remove any adhesive residue from
the shipping indicators using methylated spirits.
See also
Checking shock and tilt indicators (Page 66)
4.6
Storage
4.6.1
Emptying the drive
NOTICE
Frost damage or corrosion as a result of the coolant
The coolant can corrode the components over the long term. Coolant can also freeze at
temperatures of below 0 °C causing damage to the drive.
• Before storing the device completely drain the cooling system.
• If the drive is stored for a longer period of time, then close and seal all water intakes and
discharge points to protect against vermin and dirt.
Preparations for use
4.6 Storage
3rd Party LCI Control Upgrade
Operating Instructions, 02/2022, A5E31872818
75
