Siemens SINAMICS G120XA, Operating Instructions Manual

Page: 581 / 918

p2108[0...n] BI: External fault 3 / External fault 3
CUG120XA_USS
(PM330)
Access level: 3 Calculated: - Data type: Unsigned32 / Binary
Can be changed: T, U Scaling: - Dynamic index: CDS, p0170
Unit group: - Unit selection: - Function diagram: 2546
Min:
- Max:
- Factory setting:
4022.1
Description: Sets the signal source for external fault 3.
External fault 3 is initiated by the following AND logic operation:
- BI: p2108 negated
- BI: p3111
- BI: p3112 negated
Dependency: See also: p3110, p3111, p3112
See also: F07862
Note
An external fault is triggered with a 1/0 signal.
r2109[0...63] Fault time removed in milliseconds / t_flt resolved ms
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 8050, 8060
Min:
- [ms] Max:
- [ms] Factory setting:
- [ms]
Description: Displays the system runtime in milliseconds when the fault was removed.
Dependency: See also: r0945, r0947, r0948, r0949, r2130, r2133, r2136, p8400
NOTICE
The time comprises r2136 (days) and r2109 (milliseconds).
Note
The buffer parameters are cyclically updated in the background (refer to status signal in r2139).
The structure of the fault buffer and the assignment of the indices is shown in r0945.
r2110[0...63] Alarm number / Alarm number
Access level: 2 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 8065
Min:
- Max:
- Factory setting:
-
Description: This parameter is identical to r2122.
p2111 Alarm counter / Alarm counter
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 8050, 8065
Min:
0 Max:
65535 Factory setting:
0
Description: Number of alarms that have occurred after the last reset.
Parameters
7.3 Parameters
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
579