Siemens SINAMICS BOP-2, Operating Instructions Manual

Page: 19 / 54

Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
19
Installation
5
Fitting the BOP-2 to the Control Unit
Note
BOP-2 power supply
The BOP-2 has no internal power supply and derives its power directly from the Control Unit
through the RS232 interface. Any cloned data stored on the BOP-2 is saved to its non-
volatile memory which does not require power to retain the data.
To fit the BOP-2 to the Control Unit the following procedure should be performed:
1.
Place the bottom edge of the BOP-2 casing into the lower recess of the Control Unit
housing.
2. Push the BOP-2 towards the Control Unit until the release-catch clicks into place on the
Control unit housing.
Image 5-1 Fitting the BOP-2 to the Control Unit
To remove the BOP-2 from the Control Unit, press down on the release-catch and pull the
BOP-2 off the Control Unit.