Siemens SIMOTICS XP 1MB155, Operating Instructions Manual

Page: 64 / 152

Assembly
5.4 Installing the machine
1MB155 / 1MB555
62
Operating Instructions, 03/2018, A5E41926185A
5.4.5 Mounting the output elements
Balance quality
The rotor is dynamically balanced. For shaft ends with feather keys, the balancing type is
specified using the following coding on the rating plate:
● "H" means balancing with a half feather key
● "F" means balancing with a whole feather key
Figure 5-1 Balancing type on the drive-end side
Pushing on the power output elements
● Requirements:
–
The coupling and/or the output element must be appropriately dimensioned for the
operating case at hand.
– Comply with the coupling manufacturer's instructions.
– Make sure that the balancing type of the transmission element correctly matches the
type of balance of the rotor.
– Use only ready drilled and balanced transmission elements. Check the hole diameters
and the balancing status before pulling them on. Thoroughly clean the shaft extension.
● Pulling on:
–
Warm up the transmission elements to expand them before pulling them on. Select
the temperature difference for the heating process to suit the coupling diameter, fit and
material. See the coupling manufacturer's instructions.
– Power output elements may only be pushed on or pulled off with the correct
equipment. The transmission element must be pulled on in one continuous operation
via the front thread holes in the shaft or pushed on by hand.
– Do not strike it with a hammer, as this would damage the bearings.