Safety instructions
2.2 Notes on use
SIMATIC IPC547G
Operating Instructions, 04/2020, A5E49948632-AA
37
NOTICE
Ambient conditions and chemical resistance
Unsuitable environmental conditions can cause faults or damage the device.
Failure to comply nullifies the warranty in accordance with IEC/EN/UL/CSA 61010-2-201.
•
Operate the device only in closed rooms.
•
Only operate the device in the ambient conditions specified in the technical
specifications.
•
Observe the permitted mounting positions of the device.
•
Do not obstruct the venting slots of the device.
•
When the device is operated in severe environments which are subject to caustic vapors
or gases, ensure sufficient clean air is provided.
•
Clean the enclosure surface with a damp cloth and make sure that no water enters the
device.
When you plan your project, you should make allowances for:
●
Climatic and mechanical environmental conditions defined in the "General technical data"
chapter of the operating instructions.
●
This device was designed for use in a normal industrial environment. SIMATIC Rack PCs
may not be operated in severe environments which are subject to caustic vapors or
gases without taking additional protective measures (such as the provision of clean air.)
●
Avoid extreme ambient conditions as far as possible, for example, heat.
●
Do not expose the device to direct sunlight or other powerful light sources.
●
Install the device in such a way that it poses no danger, for example, by falling over.
●
Always maintain a minimum clearance of 50 mm to the area of the ventilation slots in
order to ensure adequate ventilation of the PC.
●
Do not cover the ventilation slots of the enclosure. There must be distance of at least 5
cm at the back of the device, depending on wiring.
●
The device meets the requirements for fire protection enclosures in accordance with
IEC/EN/UL/CSA 61010-2-201. You can therefore install it without an additional fire
protection enclosure.
●
The connected or built-in peripherals should not introduce a counter emf in excess of
0.5 V into the device.
●
The device conforms to protection class IP30 at the front panel. Ensure that the
installation opening for the device is splash-proof in areas which may be subject to splash
water.