SIMATIC RF1000
Operating Instructions, 02/2019, C79000-G8976-C432-04
13
Connecting
4
Required tools
When using preassembled cables 6GT2891-4UH20 und 6GT2891-2UH30, you need the
following tool:
●
Torx screwdriver (T8)
●
Additional tools depending on the connector used
Accessories required
You need the following accessories:
●
For communication via the USB interface
the connecting cable included in the scope of delivery
●
For communication with the RF170C communication module via the RS232 interface
the connecting cable (6GT2891-4UH20)
●
For communication via the RS232 interface
The connecting cable with open ends (6GT2891-2UH30)
Connect the plug
The procedure for connecting the reader depends on the interface over which the reader is
being operated.
Connection via USB interface
Proceed as follows to connect the SIMATIC RF1060R/RF1070R reader via the USB
interface:
1.
Connect the reader to the PC or Panel using the USB cable.
Connection via RS232 interface
Proceed as follows to connect the SIMATIC RF1070R reader via the RS232 interface:
1.
When using the cable 6GT2891-2UH30, you may have to install the cable connector.
You can find the connector assignment in the following table.
2.
Loosen the cleat on the USB cable and remove the USB cable.
3.
Connect the RS232 cable to the RS232 interface (5-pin socket).
4.
Fasten the RS232 cable using the cleat.
5.
Connect the reader to the communication module or the controller with the RS232 cable.
