5
5-7
PG 760 Programming Device
C79000-G7076-C761-01
A branch is made to the following submenu when you select this type of
menu option:
PhoenixBIOS Setup-Copyright 1985-95 Phoenix Technologies Ltd.
Item Specific Help
F1
ESC
Help
Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values
F9
F10
Setup Defaults
Previous Values
Sub-Menu
Autotype Fixed Disk
Type:
Cylinders:
[User]
Heads:
Sectors/Track:
Write Precomp:
Main
Security
Power
Exit
Advanced
IDE Adapter 0 Master (C: 1624 Mb)
[Press Enter]
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Attempts to automatically detect
the drive type for drives that
comply with ANSI specifications
1624 Mb
[ 3148]
[ 16]
[ 63]
[None]
[16 Sectors]
[Enabled]
[Enabled]
[Fast PIO 3]
Figure 5-3 “Hard Disk Drive IDE Adapter” Submenu
The parameters which you can select here are usually saved on the respective
IDE drive, and are read from the drive and entered into the form when you
select the option “Autodetect Hard Disk”. CD-ROM drives with IDE
interface (ATAPI) are not entered here.
If you select the option “Autodetect Hard Disk” for a hard disk which does
not exist, an abort is executed after a maximum of five minutes as a result of
a timeout, and the existing entries remain unchanged. It is therefore only
meaningful to carry out an autodetect for hard disks present in the system.
In the standard configuration of your programming device, only one hard
disk is entered as the master at IDE adapter 0. [none] is entered as the type
for the other drives.
Under certain circumstances it may be necessary to deviate from the
proposed hard disk parameters. In this case, select the corresponding menu
option and then the desired value using the [+] and [–] keys. Enter “none” in
the option “Type” if an IDE hard disk or an IDE CD-ROM is not connected,
or a number from 1 to 39 if a predefined type of hard disk is to be used.
Select “User” if you wish to define your own type of hard disk; you must
then additionally enter the hard disk parameters in the options “Cylinders”,
“Heads”, “Sectors/Track”, “Write Precomp”.
IDE Adapter
Hard Disk Drive
Option
“
Autodetect
Hard Disk”
Configuring the PG 760
