Siemens SIMATIC OEM PP32, Equipment Manual

Page: 21 / 69

2-3
OEM Push Button Panel Equipment Manual
Release 08/98
2.1 Configure Interface to PLC on the Push Button Panel
The settings of the interface to the PLC are menu-controlled and can be de-
fined via the rear side display of the Push Button Panel. The so-called configu-
ration mode is provided for this.
All the parameters concerning the interface to the PLC are stored in the Push
Button Panel memory module. In cases where the unit electronics or the entire
unit are replaced, the interface need not be reconfigured. Only the old memory
module needs to be transferred to the new unit.
Key Description
ESC
+
OK
If this key combination is pressed while the unit is
starting up (directly after switching on), the unit
enters configuration mode.
OK
In configuration mode, this key serves to store a
modification in the current menu level and skip for-
ward to the next menu level. The key has no func-
tion in the bottom menu level.
In configuration mode, this key serves to skip back
to the superordinated menu level. The key has no
function in the top menu level.
Caution: Any modifications carried out to the set-
tings in the current menu level are not stored.
In configuration mode, this key serves to skip for-
ward to the next menu level. The key has no func-
tion in the bottom menu level.
Caution: Any modifications carried out to the set-
tings in the current menu level are not stored.
In configuration mode, this key serves to scroll up-
wards through the alternatives within a menu level.
In configuration mode, this key serves to scroll
downwards through the alternatives within a menu
level.
ESC
This key serves to exit from configuration mode.
The current settings are stored. The key can be oper-
ated in any menu level.
Calling in and
operating
configuration
mode
Starting Up the Push Button Panel