Siemens SIMATIC NET RUGGEDCOM RS940G, Installation Manual

Page: 29 / 46

Device Management
3.2 Configuring the Device
The following is the pin-out for the port:
1 5
9
6
Figure 3.1 Serial DB9 Console Port
Pin Name Description
1
a
Reserved (Do Not Connect)
2 TX Transmit Data
3 RX Receive Data
4
a
Reserved (Do Not Connect)
5 GND Signal Ground
6
a
Reserved (Do Not Connect)
7
b
Reserved (Do Not Connect)
8
b
Reserved (Do Not Connect)
9 Reserved (Do Not Connect)
a
Connected internally.
b
Connected internally.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RUGGEDCOM RS940G console and Web interfaces via
the device's IP address. The factory default IP address for the RUGGEDCOM RS940G is
https://192.168.0.1 .
For more information about available ports, refer to " Communication Ports (Page
21)" .
3.2 Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RUGGEDCOM
RS940G interface. For more information about configuring the device, refer to
the RUGGEDCOM RUGGEDCOM RS940G User Guide associated with the installed
software release.
20
RUGGEDCOM RS940G
Installation Manual, 01/2021, C79000-G8976-1036-07