Siemens SIMATIC ET 200C, Manual

Page: 127 / 333

5-5
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b
5.1.2 Enter Address Area and Station Type
If the station has not already been configured, two additional entry fields
“Area” and “Station type” appear in the “CONFIGURING” screen after entry
of the station number (see Section 5.1.1).
Address area and station type of the ET 200C are defined as follows:
1. Enter the address area of the station in the “Area” entry field.
Entry options:
If you entered “Y” for the ET 200 system parameter “Dual-port RAM
ADDR”, you must enter the abbreviation of the peripheral area (example:
“P3” for dual-port RAM page number 3 in the P peripheral area).
If you entered “N” for the ET 200 system parameter “Dual-port RAM
ADDR”, you must select one of the permissible areas for linear
addressing (P or Q).
Note
The ET 200 Distributed I/O System manual describes the basic principles of
address assignment for ET 200 (linear addressing or dual-port RAM
addressing).
2. Enter the corresponding name for your ET 200C station in the “Station
type” entry field. (see Table 5-1)
Help:
Press <F7> to make a window appear with all station types that can be
entered in the entry field.
3. Confirm your entries by pressing <F6> (ENTER).
On completion of the entries, additional entry fields and a table for configur-
ing the inputs or outputs appear in the CONFIGURING screen
(see Section 5.1.3).
Basic Requirement
Procedure:
Enter Address
Area and
Station Type
Result
Address Assignment and Parameterization with COM ET 200